ESP32

https://news.ycombinator.com/item?id=40147335

As a fellow lazy hobbyist, I'm gonna suggest that buying the cheapest ESP32 / -C3 / -C6 boards can be a poor value. The cheap ones are often > 25.4mm wide so on a single standard breadboard the pins are only accessible on one side[0]. Also having recently been fighting CircuitPython running out of memory parsing a ~35KB response from a web service, boards with some PSRAM are real nice to have. And speaking of CircuitPython, ESP32-S3/S2 boards can run the UF2 bootloader for that Pi Pico-like experience.

Waveshare's super compact ESP32-S3-Mini (or Zero) has become my first-to-grab. For 5 direct from their China site it works out to $7.35/ea pre-soldered with shipping or save a buck each for unsoldered. 2MB PSRAM and 13 usable GPIO. They also have less cheap -S3 boards in Arduino Nano ESP32, Pi Pico, and ESP32-S3-DevKitC-1[1] formats. And the oddball ESP32 One in Pi Zero format, using an ESP32 w/ off-die PSRAM. They sell on Amazon, too.

A genuine Espressif ESP32-S2-DevKitC-1-N8R2 is $8 on Amazon, a relative bargain if you need it tomorrow and can live with one less LX7 core and no Bluetooth.

[0] If you use the trick of spanning two breadboards side-by-side, that's an extra cost that could have gone towards a better smaller board.

[1] Beware of cheap boards claiming to be copies of Espressif's 25.4mm board designs, many have been widened to ~28mm. Bad ESP32-S[3|2]-DevKit[C|M]-1 copies give themselves away by having enough room on top to put pin labels next to the pins instead of between them.

DUMB BREADBOARD STUFF

• Breadboard hole pitch standard is 2.52mm/0.1". Cheap Chinese versions shorten the pitch to around 2mm, for some dumb reason. 

  • Check via caliper - measure using calipers across 30 holes or more, then divide length by 30 for close estimate for hole pitch.